产品名称：PP丝印/移印油墨系列 PP丝印油墨,PP移印油墨, 一 承印物：PP，PE，及类似的材质 产品举例：塑玩具,家电塑胶外壳,塑胶铭牌,商标牌 二 产品特性： 1、对已处理的PP,PE和部分未处理的PP材质有良好的附着力,耐酒精,遮蔽性优秀 2、适用于丝印和移印工艺 3、产品细度:5um以下 三 使用说明： 1 丝印 网板：150—400目聚脂丝网印版 胶刮：建议使用65-75度胶刮 用量：350目网板印刷约为40㎡/kg 干燥: 自然干燥,表干15-20分钟,实干3小时以上或100℃以下温度烘干,约25分钟 2 移印 溶剂: 10-20%溶剂稀释后印刷，718快干水,783慢干水,因印刷环境温度不同进行选择 清洗: 选用有机溶剂清洗（如：718,783） 用量：约为45㎡/㎏ 四 注意事项: 以上是以我司的测试结果,谨供参考。量产前务必在贵司的条件下,再次测试为盼。 五 产品包装: 1公斤装、5公斤装、20公斤装 六 储存条件: 5℃—25℃条件下可存放两年,避免强光照射,防接触强酸,强碱。Product name: PP silk screen/moving printing ink series PP silk screen ink, PP moving printing ink, a print content: PP, PE, and similar material products for example: plastic toys, home appliance plastic shell, plastic nameplates, trademark brand two characteristics: 1, has been treated PP, PE and some did not handle PP material has good adhesion, resistance to alcohol, cover sex good 2, apply to screen printing and pad printing process 3, product fineness: 5 um three instructions: 1 printing screen: 150-400 mesh polyester silk screen printing plastic blow: suggest using 65-75 degrees glue scraping the dosage: 350 mesh screen printing of about 40 ㎡ / kg dry: natural drying, table dry 15 to 20 minutes, action 3 hours or 100 ℃ below temperature drying, about 25 minutes 2 moving printing solvent: 10-20 ? and ? ? agent diluted printing, 718 quick dry water, 783 slow dry water, for printing environment temperature choose different cleaning: choose organic solvents washing （such as: 718783） usage: about 45 ㎡ / ㎏ four note: the above is based on our testing results, only for reference. Be sure to be in your company quantity antenatal, under the condition of test for hope again. Five product packaging: 1 kg outfit, 5 kg outfit, 20 kg outfit six storage conditions: 5 ℃-25 ℃ conditions can deposit two years, avoid glare, the contact of strong acid, strong alkali.